[. . . ] Helium / Hi-FloatTM Adapter Instruction Sheet Hi-FloatTM Adapter - Set Up 1 Firmly press-fit connect the Helium/Hi-Float Adapter on to the outlet of the Hi-Float pump. [. . . ] (Note, if you misplace the pump cap, a 5-inch or smaller balloon stretched over the tip works well. ) · If Hi-Float clogs the Helium/Hi-Float Adapter remove the Adapter from the pump and flush it with warm water. Warm water dissolves dried Hi-Float. Hi-FloatTM Power Pump Instruction Sheet Hi-FloatTM Power Pump - Set Up Tips T-4-2 Adapter · If the balloons are going to be treated and immediately inflated use the T-4-2 Adapter on a helium cylinder. The T-4-2 Adapter will enable two regulators to work off one helium cylinder. Hand-tighten the Power Pump regulator and the Duplicator 2 or Dual Sizer regulator to the T-4-2 Adapter. · If you're pre-treating balloons with Hi-Float to be inflated at a later time, nitrogen is a more economical gas to use. · Follow Hi-Float's charts and recommendations to use the appropriate amount of Hi-Float in the balloon. · Visit www. Hi-Float. com to learn more about working with Hi-Float. If pre-treating balloons to be filled with helium at a later time, skip step 3. 1 Connect the Power Pump regulator to a nitrogen or helium cylinder. 2 Place a large bottle of Ultra Hi-Float on the holder and secure in place with the Velcro belt. 3 Hook the wire loop under the pump handle. [. . . ] Visit ConwinOnline. com to see our complete line of educational videos. 10292004 Visit www. ConwinOnline. com today! [. . . ]